Contact
Series
MXXX0

Clamping elements

Elements for holding and clamping components
Clamping elements
Downloads
Catalogue sheet
No catalog sheets available.
Operating instructions
Available on demand.
Information Series

Clamps for assembly technology have to meet different requirements than, for example, clamps for machining. Priority is given to safe clamping; it is essential to prevent the workpiece from falling out.
Therefore, the capabilities of status indication / clamping sensing and self-locking are of particular importance. 

Different drive energies can be used:
Manual, pneumatic; electric; hydraulic.

Due to the setup with a crane or by hand, pre-positioning and active retraction of the tensioner can be very important. From an ergonomic point of view, the tensioner should not form a shearing edge.

STARK.easyclick

Single-acting, pneumatic
The STARK.easyclick is a mechanical quick-release fastener that clicks and holds immediately without energy supply.
To release it, it only needs an air connection with 4 - 8 bar pressure.
85 mm diameter and only 19 mm high
5 kN clamping force - 10 kN holding force
Release time 0.1 sec
Focus: Vertical arrangement;
Secure holding of workpieces on flat surfaces

READ MORE

 

Block clamps B1.8233

with self-locking
max. clamping force 7.5 kN
max. clamping stroke 6 mm

Focus: Applications with workpieces with clamping lugs and optional turning in the application.
Due to the high clamping force and self-locking, the workpieces are also held securely during turning (device with corresponding design and safety consideration necessary).

READ MORE